fix: 修复以太网控制逻辑，调整硬件版本引脚映射

1. 移除main.h中的软硬件版本宏定义，移至bsp.h
2. 新增ETHStop和ETHReset对外接口并实现对应逻辑
3. 注释掉原有的ETH硬件复位延时流程
4. 根据硬件版本适配ETH和CAT1的引脚控制逻辑
5. 清理冗余的CAT1电源引脚宏定义

Project/GateWay/source/User/Inc/bsp.h

@@ -10,6 +10,9 @@
 #include "rtthread.h"
 #include "ff.h"
 
+#define	SOFTWARE_VERSION								12
+#define	HARDWARE_VERSION								12
+
 //#define	USE_BOOTLOADER
 
 //#define FLASH_SECTOR_SIZE           		0x2000ul                     
@@ -164,8 +167,14 @@
 
 #define ETH_OR_CAT1_CTRL_PORT							(PortB)
 #define ETH_OR_CAT1_CTRL_PIN							(Pin08)
+
+#if (HARDWARE_VERSION == 12)
 #define	ETH_ON()													PORT_SetBits(ETH_OR_CAT1_CTRL_PORT, ETH_OR_CAT1_CTRL_PIN)
 #define	CAT1_ON()													PORT_ResetBits(ETH_OR_CAT1_CTRL_PORT, ETH_OR_CAT1_CTRL_PIN)
+#elif (HARDWARE_VERSION >= 13)
+#define	ETH_ON()													PORT_ResetBits(ETH_OR_CAT1_CTRL_PORT, ETH_OR_CAT1_CTRL_PIN)
+#define	CAT1_ON()													PORT_SetBits(ETH_OR_CAT1_CTRL_PORT, ETH_OR_CAT1_CTRL_PIN)
+#endif
 
 //#define ETH_OR_CAT1_TX_CTRL_PORT					(PortH)
 //#define ETH_OR_CAT1_TX_CTRL_PIN						(Pin02)
@@ -182,11 +191,6 @@
 #define	CAT1_RESET_CLR()									PORT_SetBits(CAT1_RESET_PORT, CAT1_RESET_PIN)
 #define	CAT1_RESET_SET()									PORT_ResetBits(CAT1_RESET_PORT, CAT1_RESET_PIN)
 
-//#define	CAT1_POW_PORT											(PortA)
-//#define	CAT1_POW_PIN											(Pin00)
-//#define	CAT1_POW_ON()											PORT_SetBits(CAT1_POW_PORT, CAT1_POW_PIN)
-//#define	CAT1_POW_OFF()										PORT_ResetBits(CAT1_POW_PORT, CAT1_POW_PIN)
-
 #define	ETH_RESET_PORT										(PortB)
 #define	ETH_RESET_PIN											(Pin05)
 #define	ETH_RESET_SET()										PORT_SetBits(ETH_RESET_PORT, ETH_RESET_PIN)